Pinterest でおしゃれアイデアをまとめましょう!

関連トピックを見てみる

Dimple Dies are Heat Treated and Will Work Panels up to 0.1875". These Dies Are Used To Flare or Flange an Existing Hole In Sheet Metal. Dimpled Sheet Metal Becomes Stronger, More Rigid and Lighter Weight. And it Creates a Custom Appearance.

Dimple Dies are Heat Treated and Will Work Panels up to 0.1875". These Dies Are Used To Flare or Flange an Existing Hole In Sheet Metal. Dimpled Sheet Metal Becomes Stronger, More Rigid and Lighter Weight. And it Creates a Custom Appearance.

Advanced products for shaping the future. info@hammerfab.com

Advanced products for shaping the future. info@hammerfab.com

ROUND CUTTING ATTACHMENT

ROUND CUTTING ATTACHMENT

SWAG Dimple Dies (8) Piece Set

SWAG Dimple Dies (8) Piece Set

MAKING OF VISE

MAKING OF VISE

This bench-top box/pan brake can bend sheet metal into various shapes. It mounts to a workbench. It can accept up to four foot wide stock and bend 135 degrees. With the various width teeth, they can be adjusted to fit the width of the bend needed within minutes with one wrench. The clamping thickness can be adjusted from 0 to about 0.25 inches, but I would be extremely lucky to bend something that thick. The throat can open to over four inches. This brake was built from scrap I received…

This bench-top box/pan brake can bend sheet metal into various shapes. It mounts to a workbench. It can accept up to four foot wide stock and bend 135 degrees. With the various width teeth, they can be adjusted to fit the width of the bend needed within minutes with one wrench. The clamping thickness can be adjusted from 0 to about 0.25 inches, but I would be extremely lucky to bend something that thick. The throat can open to over four inches. This brake was built from scrap I received…

nice little homemade screw jack for workholding.  note the sweet square threads.

nice little homemade screw jack for workholding. note the sweet square threads.

These dimple dies by JMR add that "trick" look to any fabrication project and help strengthen panels with lightening holes.  Commonly used in an ironworker or press, these dies can handle up to 1/8 inch 4130.  Sold in sets or individually.

These dimple dies by JMR add that "trick" look to any fabrication project and help strengthen panels with lightening holes. Commonly used in an ironworker or press, these dies can handle up to 1/8 inch 4130. Sold in sets or individually.

KEYWAY CUTTING TOOL - Lathe dedicated tool for making square holes and keyways for parts held in headstock chuck.

KEYWAY CUTTING TOOL - Lathe dedicated tool for making square holes and keyways for parts held in headstock chuck.

Need to add a little bit of detail to your work?  Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel.  These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish.  Dimensions are 1.5" diameter by approximately 1" combined height.   Each one of these dies have been tested on 22, 20, and 18ga mild steel…

Need to add a little bit of detail to your work? Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel. These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish. Dimensions are 1.5" diameter by approximately 1" combined height. Each one of these dies have been tested on 22, 20, and 18ga mild steel…

Pinterest
検索